< Prev. Page

Rear Fender

Rear fender and wheel mounted.

Front Fender

Front fender with trim and front wheel mounted.

Seat Bracket Spacer

The spring mounted solo seat that I am using required mounting a support bracket for the springs. This bracket is flat and the only logical place to mount it was on the rear fender where the U brackets attach the fender to the frame tube. I had to fabricate some sort of spacer that would allow the flat bracket to be bolted to the curved fender without crushing the fender. So I came up with what you see here. It is made from PVC.

The HOG Has Landed

At approx. 3:00PM on Saturday, July 24, I took it down from the lift. This is the first time since early November that it has been free-standing on its own.

Wire Looms

Just showing the routing of some of the wire looms. I haven't checked the fit of the gas tanks yet so I may end up relocating some of these if they interfer.

Horn

I know this is not the proper location for the horn. This is a temporary setup - I plan to eventually install a trumpet horn. I just wanted to get something on it to make it legal (it didn't have a horn when I got it).

Lighting - Front

View from the front showing the new headlight, spot lights and turn signals.

Lighting - Front Turn Signal

Showing the installation of the front turn signal. I plan on changing this because I don't really like the way the mounting stud and wire are sticking up like that. Maybe I can bend the bracket at a right angle so that it is hanging down, then mount the turn signal so that the mounting stud and wire are pointing toward the center.

Lighting - Rear

Tail light and rear turn signals.

Lighting - Rear Turn Signal

Close-up of rear turn signal mounting.